Optocoupler Integrated Circuit

The General purpose 6-pin dual in-line package, optocouplers comprise of a gallium arsenide infrared emitting diode driving a silicon phototransistor.

The MOC303XM and MOC304XM devices consist of a AlGaAsinfrared emitting diode optically coupled to a monolithic silicondetector performing the function of a zero voltage crossing bilat-eral triac driver. They are designed for use with a triac in the interface of logicsystems to equipment powered from 115 VAC lines, such asteletypewriters, CRTs, solid-state relays, industrial controls,printers, motors, solenoids and consumer appliances, etc.

The general purpose optocouplers consist of a gallium arsenide infrared emitting diode driving a silicon phototransistor in a 6-pin dual in-line package

The MOC301XM and MOC302XM series are optically isolated triac driver devices. These devices contain a GaAs infrared emitting diode and a light activated silicon bilateral switch, which functions like a triac. They are designed for interfacing between electronic controls and power triacs to control resistive and inductive loads for 115 VAC operations

A 850 nm AlGaAS LED is optically connected to a very fast speed integrated photo-detector logic gate with a strobable output in the 6N137M, HCPL2601M, HCPL2611M single-channel and HCPL2630M, HCPL2631M dual-channel optocouplers. Because this output has an accessible col-lector, wired OR outputs are possible. Over a heating rate of -40°C to +85°C, the switching characteristics are assured. A 5mA maximum input signal will result in a 13mA minimum output sink current (fan out of 8). An interior noise shield provides enhanced common mode rejection of approximately 10kV/s. The minimum CMR of the HCPL2601M and HCPL2631M is 5kV/s. The minimum CMR of the HCPL2611M is 10kV/s.

The FOD817 Series consists of a gallium arsenide infrared emitting diode driving a silicon phototransistor in a 4-pin dual in-line package

A AlGaAs infrared emitting diode is optically connected to a monolithic silicon detector that acts as a zero voltage crossing bilateral triac driver in the MOC303XM and MOC304XM devices. They are intended for use with a triac in the connection of logic systems to 115 VAC-powered devices such as teletypewriters, CRTs, solid-state relays, industrial controls, printers, motors, solenoids, and consumer appliances, among other things.

The MOC306XM and MOC316XM devices consist of aGaAs infrared emitting diode optically coupled to amonolithic silicon detector performing the function of azero voltage crossing bilateral triac driver. They aredesigned for use with a triac in the interface of logic sys-tems to equipment powered from 115/240 VAC lines,such as solid-state relays, industrial controls, motors,solenoids and consumer appliances, etc

General Purpose Type Photocoupler
We also have all the products mentioned below in ready stock
LTV-4N26 Series
LTV-4N27 Series
LTV-4N28 Series
4N25 Series/4N26 Series/4N27 Series/4N28 Series

The CNY17, CNY17F and MOC810X devices consist of a Gallium Arsenide IRED coupled with an NPN phototransistor in a dual in-line package

The MCT6X Optocouplers have two channels for densityapplications. For four channel applications, two-pack-ages fit into a standard 16-pin DIP socket. Each channelis an NPN silicon planar phototransistor optically coupledto a gallium arsenide infrared emitting diode