Integrated Circuit

The TLP152 is a SO6-packaged photocoupler that comprises of an optically linked GaAlAs infrared LED and an integrated high-gain, high-speed photodetector IC chip. The photodetector IC chip includes an internal shield that offers better noise immunity between the input and output pins and a strong common-mode transient immunity of around 20 kV/s. A totem-pole output on the TLP152 may source and drain current. It is excellent for power MOSFET or tiny IGBT direct driving.

A current-mode PFC controller that runs in transition mode (TM) is the L6562AD. It delivers better performance and has the same pin-out as its predecessors, the L6561 and L6562. With the help of a unique circuit that can lower AC input current distortion, the highly linear multiplier enables broad-range mains operation with incredibly low THD even across a wide load range. It is possible to properly handle overvoltage that arises at startup or as a result of load disconnection using an efficient 2-step OVP. The totem-pole output stage may drive high current MOSFETs or IGBTs since it has a 600 mA source and 800 mA sink current capability. This, together with the other characteristics and the option to use the patented fixed-off-time control, makes the device a great choice for SMPSs that are over 350W and comply with EN61000-3-2 standards.

Doingter s s innovative HEXFET Power MOSFETs use cutting edge manufacturing methods to provide extraordinarily low on resistance per silicon area This feature offers the designer a highly efficient and dependable device for usage in a range of applications in addition to the quick switching speed and ruggedized device architecture that HEXFET power MOSFETs are widely known for For all commercial and industrial applications with power dissipation levels up to about 50 watts the TO 220 package is always favoured The TO 220 is widely used in the industry because to its low thermal resistance and affordable packaging

The TOSHIBA TLP731 and TLP732 are infrared emitting diodes made of gallium arsenide that are optically connected to a phototransistor in a six lead plastic DIP package. For high-EMI situations, TLP732 is an internal connection with no base. 

The MC34151 and MC33151 are twin inverting high speed drivers that were created especially for uses where low current digital circuitry is required to drive large capacitive loads at rapid slew rates. These devices include two high current totem pole outputs that are perfect for driving power MOSFETs, low input current that enables CMOS and LSTTL logic compatibility, input hysteresis enabling quick output switching that is independent of input transition time, and low input current. An undervoltage lockout with hysteresis is also present to avoid erratically operating systems at low supply voltages. Switching power supplies, dc to dc converters, voltage doublers/inverters for capacitor charge pumps, and motor controllers are examples of typical uses.

The MCP492X from Microchip Technology Inc. is a 12-bit, 2.75.5V, low-power, low DNL DAC with an optional 2x buffered output and an SPI interface. For industrial applications requiring the calibration or correction of signals (such as temperature, pressure, and humidity), the MCP492X DACs offer excellent accuracy and low noise performance. The MCP492X is offered in the PDIP, SOIC, MSOP, and TSSOP packages and has an expanded temperature range. The resistive string design used by the MCP492X devices has the features of minimal DNL error, low ratio metric temperature coefficient, and quick settling time. These devices have a wide temperature range specification.

In situations where compromises were previously required due to low voltage supply or power restrictions, the LM6132/34 offers new levels of speed vs. power performance. The 10 MHz gain-bandwidth of this device facilitates new portable applications where higher power devices severely deplete battery life with just 360 A/amp supply current.
Concerns about exceeding the common-mode voltage range are dispelled because the LM6132/34 can be driven by voltages that are greater than both power supply rails. The largest dynamic range at the output is provided by the rail-to-rail output swing capacity. This is especially crucial when using low supply voltages. Large capacitive loads may be driven by the LM6132/34 without oscillating.

Established in the year 2016 at Mumbai Maharashtra we Adinath Electronics are a Sole Proprietorship based firm engaged as the foremost Wholesale Supplier and Importer of SMD Resistors PCB Connector etc Our products are high in demand due to their premium quality and affordable prices Furthermore we ensure to timely deliver these products to our clients through this we have gained a huge clients base in the market we are importing our products from Taiwan Singapore and Malaysia

Established in the year 2016 at Mumbai Maharashtra we Adinath Electronics are a Sole Proprietorship based firm engaged as the foremost Wholesale Supplier and Importer of SMD Resistors PCB Connector etc Our products are high in demand due to their premium quality and affordable prices Furthermore we ensure to timely deliver these products to our clients through this we have gained a huge clients base in the market we are importing our products from Taiwan Singapore and Malaysia. 
WE are dealers of Data Conveter IC in Mumbai

The step-down (buck) switching regulators of the LM2576 series are monolithic integrated circuits that are capable of driving 3-A loads with good line and load control. These devices come with 3.3 V, 5 V, 12 V, 15 V fixed output voltages as well as an adjustable output version.

STMicroelectronics manufactures the STGF3NC120HD, a 7 A, 1200 V very fast IGBT with an ultrafast diode. It can operate between -55 and 150 degrees Celsius. Utilising state-of-the-art high voltage technology and a patent-pending strip arrangement, the STGF3NC120HD was created. Its 3-pin TO-220FP configuration.