Electronic Integrated Circuit

The M48Z08/18 ZEROPOWER® RAM is an 8K x8 non-volatile static RAM which is pin and func-tional compatible with the DS1225. The monolithicchip is available in two special packages to providea highly integrated battery backed-up memory so-lution

TheHCC 4051B, 4052Band4053B(extended tem-perature range) andHCF4051B, 4052Band4053B(intermediate temperature range) are monolithic in-tegrated circuits, available in 16-lead dual in-lineplastic or ceramic package and plastic micropack-age.HCC/HCF4051B, HCC/HCF4052B, andHCC/HCF4053Banalogmultiplexers/demulti-plexers are digitally controlled analog switches hav-ing low ON impedance and very low OFF leakage current.

The LM2596 series of regulators are monolithic integrated circuits that are perfect for designing step-down switching regulators quickly and easily (buck converter). This series' circuits can all drive a 3.0A load with excellent line and load regulation. Fixed output voltages of 3.3V, 5.0V, 12V, 15V, and an adjustable output version are available. These regulators were created with the goal of reducing the amount of external components in the power supply architecture. Several inductor manufacturers offer standard series inductors that are tailored for use with the LM2576.In many circumstances, the amount of power dissipated is so minimal that a heatsink is not necessary, or its size can be drastically decreased. Several manufacturers offer a standard set of inductors that are tailored for use with the LM2596. This feature makes the design of switch-mode power supply a lot easier. The LM2596 has a guaranteed +/-4% output voltage tolerance within defined input voltages and output load circumstances, as well as a +/-15% oscillator frequency tolerance (+/-2% over 0oC to 125oC). External shutdown is included, with a standby current of 80 uA (typical). The output switch has cycle-by-cycle current limiting and thermal shutdown for complete protection in the event of a fault.

• Integrated Circuits
• Logic IC
• Switching Regulator
• Voltage Regulator

The M27C512 is a 512 Kbit EPROM offered in thetwo ranges UV (ultra violet erase) and OTP (onetime programmable). It is ideally suited for applica-tions where fast turn-around and pattern experi-mentation are important requirements and isorganized as 65536 by 8 bits

The DS1225Y 64K Nonvolatile SRAM is a 65,536–bit nonvolatile RAM that is structured as 8192 words by 8 bits and is totally static. Each NV SRAM is equipped with a self–contained lithium energy source and control circuitry that continuously monitors VCC for out–of–tolerance conditions. When this happens, the lithium energy source is turned on immediately, and write protection is enabled unconditionally to prevent data corruption. The NVSRAM can be used to replace existing 8K × 8 SRAMs that are natively compatible with the common byte wide 28–pin DIP standard.The pinout of the DS1225Y matches that of the 2764 EPROM or 2864 EEPROM, allowing for straightforward replacement while improving performance. There is no limit to the number of write cycles that can be performed, and microprocessor interface does not necessitate any additional support hardware.

8-bit Microcontrollers - MCU 1.75KB 64 RAM 12 I/O Ind Temp PDIP14

The CT3010, CT3011, CT3012, CT3020, CT3021, CT3022 and CT3023 consists of a Random Phase Photo Triac optically coupled to a gallium arsenideInfrared-emitting diode in a 6-lead DIP package with different lead forming options

we have this product availabe with us in ready stock at best price and great quality

The LM2576 series of regulators are monolithic integrated circuits that are perfect for designing a step-down switching regulator quickly and easily (buck converter). This series' circuits are all capable of driving a 3.0A load while maintaining excellent line and load control. These devices come with fixed output voltages of 3.3V, 5.0V, and 12V, as well as an adjustable output option. These regulators were created with the goal of reducing the amount of external components in the power supply architecture. Several inductor manufacturers offer standard series inductors that are tailored for use with the LM2576. The efficiency of the LM2576 converter is much higher than that of typical three-terminal linear regulators, especially at higher input voltages, because it is a switch-mode power supply.In many circumstances, the power dissipated is so minimal that a heatsink is not required, or its size can be drastically decreased. Several different manufacturers offer a standard series of inductors that are optimised for use with the LM2576. This feature makes the design of switch-mode power supply a lot easier. The LM2576 has a guaranteed +/- 4 percent output voltage tolerance within defined input voltages and output load circumstances, as well as a +/-10 percent oscillator frequency tolerance (+/- 2 percent over 0 to 125 C). External shutdown is included, with a standby current of 80A (typical). The output switch has cycle-by-cycle current limiting and thermal shutdown for complete protection in the event of a fault.

The CD4049UB and CD4050B devices are inverting andnon-inverting hex buffers, respectively, and feature logic-level conversion using only one supply voltage (VCC). Theinput-signal high level (VIH) can exceed the VCC supplyvoltage when these devices are used for logic-levelconversions. These devices are intended for use as CMOSto DTL/TTL converters and can drive directly two DTL/TTLloads. (VCC = 5V, VOL≤ 0.4V, and IOL≥ 3.3mA.

We have all the products mentioned below in stock.
CD4012     CD4013      CD4017  
CD40175   CD4020      CD4023
CD4024     CD4025      CD4028
CD4029     CD4033      CD4040
CD4041     CD4042      CD4046
CD4049     CD4050      CD4051
CD4052     CD4053      CD4060

We have the entire ATMEL 1304 IC series availabe with us at best price and in ready stock.

All these products are available in DIP

IRFZ44  IRFZ44ESTRLPBF
IRFZ44VPBF IRFZ44NPBF 
IRFZ44RPBF IRFZ44ZPBF
IRFZ44STRLPBF  IRFZ44RPBF-BE3
IRFZ44PBF-BE3 IRFZ44SPBF 
IRFZ44NSTRLPBF IRFZ44NLPBF
IRFZ44EPBF  IRFZ44VZPBF
IRFZ44PBF  IRFZ44ZLPBF 
IRFZ44ZSTRRPBF IRFZ44VZSPBF 
IRFZ44ESTRRPBF 

The DS1220Y 16k Nonvolatile SRAM is a fully static, 16,384-bit nonvolatile RAM that is structured as 2048words by 8 bits. Each NV SRAM is equipped with a self-contained lithium energy source as well as control circuitry that constantly monitors VCC for out-of-tolerance conditions. When this happens, the lithium energy source is automatically turned on, and write protection is engaged unconditionally to safeguard data from corruption. Existing 2k x 8 SRAMs directly complying to the common byte wide 24-pin DIP standard can be replaced with the NV SRAM. The pinout of the DS1220Y matches that of the 2716 EPROM or 2816 EEPROM, allowing for straightforward replacement while improving performance. There is no restriction on the number of write cycles that can be performed, and no additional support circuitry is required for microprocessor interfacing

An accurate 20-bit analog-to-digital converter is the ADS1232 (ADC). The ADS1232 offers a full front-end solution for bridge sensor applications, such as weigh scales, strain gauges, and pressure sensors, thanks to its onboard low-noise programmable gain amplifier (PGA), inbuilt oscillator, and precision 20-bit delta-sigma ADC.
There are no digital registers to programme because all of the ADS1232's capabilities are controlled by specific pins. The MSP430 and other microcontrollers receive data output through an easily isolable serial interface.

The ILX3232 is a low-power, high-data-rate EIA/TIA-232 and V.28/V.24 communication module that runs on 3V. The ILX3232 features a low-dropout transmitter output stage that delivers real RS-232 performance from 3 to 5.5V supply. For operation from a 3V supply, the device simply requires four modest 0.1F standard external capacitors. Two receivers and two drivers are included in the ILX3232. The device is guaranteed to operate at 250Kbps data rates while preserving RS-232 output levels. Notebook, Subnotebook, and Palmtop Computers, Battery-Powered Equipment, Hand-Held Equipment, Peripherals, and Printers are examples of typical applications.